Reply to MIDI Out for Select/Store Hotcue using color pads on F1 - Help

Hi all,

I am mapping the Select/Store Hotcue to pads on my F1. I'm trying to get the out working to show the right color based on the hot cue type using the fewest number of modifiers.

I thought that I could accomplish this buy creating one mapping command for each cue type and setting the Controller Range to identify the cue type that should be in affect.

-1 - no mapping
0 - Grid
1 - Cue Point
2 - Load
3 - Fade In
4 - Fade Out
5 - Loop

So, I assumed that (for example) if I had Pad 1 mapping set to Cyan for Hotcue 1 when Controller Range is set to 1 - 1 then the button should be Cyan and when the mapping is set to Green with a controller range of 5 - 5 then the button would be either Cyan or Green depending on if the stored hot cue was a cue point or a loop.

However, this doesn't seem to work. The only way I have been able to get any success was by doing it differently using a modifier to check the Hotcue state. Though, I would really like to not use that modifier condition as I would like to use that condition check for something else.

What I am misunderstanding about the controller range? Can I get it to work so that I can control the color of the pad without using modifiers?

Cheers!