Reply to DJTT VCI-400 Ean Golden Edition Mapping (Traktor Pro 2)

This is to be used as the official thread for the DJ Techtools VCI-400SE Ean Golden Edition mapping for Traktor Pro 2. TO use this mapping, please make sure to be running at least TPro2 version 2.1 or greater to avoid any unexpected issues. The mapping was tested and created on TPro2 v2.1.2.

PLEASE NOTE: The VCI-400SE (Ean Golden Edition) has DJ Techtools custom firmware on the controller so this mapping WILL NOT function correctly as expected with regular VCI-400 units.

After downloading the mapping, you will need to Import the mapping into Traktor using the large "Import" button on the bottom left of the Preferences section (note that using this large Import button will overwrite all other loaded mappings, so please export your current settings first if you want to back them up).

If it is the first time importing this mapping, you will want to go through the Import process twice due to an infamous Traktor bug where the Effect settings do not load properly on the first Import. You can verify if the effect settings loaded correctly by trying the "Gratify" effects or any of the "JogFX" and ensuring that the proper effects load (this can be checked with the Summary pdf as the expected effects are listed in there).

After importing the mapping, you will want to go into the Controller Manager of Traktor's Preferences, select the DJTT VCI-400SE mapping in the "Device" listbox and make sure your In-Port and Out-Port are set correctly. "All Ports" is ok to keep if this is the only controller you have plugged into your computer. Otherwise, you may want to set the In-Port and Out-Port specifically to the VCI-400 to avoid any potentially Midi confusion between mappings.

Note: The mapping and pdf summary should have been sent in your Shipping confirmation email; however, in the case you did not receive it, I have reposted the tsi and pdf summary to this thread.

Should you find any bugs or have any questions regarding the mapping, please use this community thread to post your comments. Thanks!

DJTT VCI-400_TSI_v1.1.1.tsi
DJTT VCI400SE Mapping Summary.pdf

NOTE: There will be a tutorial video for this mapping early next week. We have to refilm now because our media got corrupted. We will also likely shoot a setup video too.

For now, after loading the mapping you want to move most knobs and faders to reset them correctly. You will also want to press Shift+Tempo Fader middle position (where the red light turns on) for each Tempo fader upon starting up Traktor. This will properly set the tempo range to +-8% (instead of 0% to 16%). This occurs because the default Tempo command is a relative command with a total range of 16%. Shift+ the Tempo fader is a direct Tempo fader command with a range of +-50%. This range can be changed in the Transport section of Preferences.

UPDATE: See below for the VCI-400SE Mapping Tutorial Video I did recently. Hope it helps!