Reply to Advanced Fx use Cases

Hi I'm remapping a setup for the controller that i use now i came across a little problem and was curious if any1 knows if it's possible or how to make that setup it kind worked till a certain point for me

so it goes like, wanting to use the different fx's

i have like

2 rows of 4 buttons let's call the upper by letters and bottom by numbers

Upper row A is for example a t3delay, B a Beatmasher , C a Reverb, D a Phaser
with those buttons i can select that fx instantly

Bottom row are buttons to load the upper row Fx's in certain FX slots by using Hold as param on that button
Button 1 = FX slot 1, Button 2 = FX slot 2, Button 3 = FX slot 3, Button 4 = FX slot 4
so holding one of the lower button and selecting one of the upper will load that fx in a certain FX slot

now comes the hard part

above every upper button there is a Fader for dry n wet params, and above those faders there are Knobs
so each fader and each button works for the Fx Slot underneath it

So Fader1 & knob1 = FX slot 1, etc...

now i have makro parameters to use with the fader and knobs but when selecting an effect
I want those params to be loaded on the fader and knob for that slot

How do I do that ?

as for example

upper button A = t3 i select that for slot one

so the fader and the knob should have the preprogrammed params for that fx

When i then select another effect for that same FX slot
it has 2 load other pre programmed params for the fader and knob

so that for each effect i have different preprogrammed params for the Fader and Knob

Thnx in advance
sincerly yann